Paradyne COMSPHERE
3610 Quick Reference Manual page 10

Model 3610: DDS Network Connection
To connect the DSU to the DDS network:
"
Procedure
1. For countries other than Canada, use an 8-pin to 8-pin network cable (Feature
Number 3600-F3-501 or 3600-F3-502). Plug either end into the wall jack.
For Canada, ensure that approved primary protectors have been installed on the
circuit in accordance with Article 800 of the National Electric Code, NFPA 70, in the
United States and Section 60 of the Canadian Electric Code, Part 1, in Canada.
Plug the 6-pin cable end (Feature Number 3600-F1-006) into the wall jack.
2. Plug the other end of the cable into the DSU jack labeled LINE.
If a remote DSU is also connected to the network and there are no other facility alarms,
the:
H
DSU's green OK LED lights.
H
Alrm indicator is no longer lit.
H
Health and Status screen no longer displays a No Signal message. The DDS data
rate displays Auto while detecting a rate. Change the Rate(Kbps) to a set rate
when the data rate has been detected.
If connecting the DSU to a LADS network, set the data rate. There are distance
limitations that govern the use of DSUs on the network.
DDS Network
Connection
Line
W
P O
10
5
V . 3
/ D C
C C
U P
C K
B A
E
L I N
E R
RJ48S
Wall Jack
495-14578-02