Model 3610: DTE Connections
The distance between the DSU and the DTE must be within the EIA-232 or V.35
interface limits.
To install the Model 3610 DTE connection:
"
Procedure
1. Connect the plug end of the DTE cable to the proper port on the back panel of the
DSU (EIA232 or V.35). Tighten the two holding screws, if present, to secure the
connector.
POWER
Power
NOTE:
If connecting the DTE to the V.35 connector, set the DTE Port in General
Configuration Options to V.35 so the DSU can communicate with the DTE. The
default for this configuration option is EIA232.
2. Connect the other end of the cable to the appropriate port on the DTE. Tighten the
two holding screws, if present.
3. Perform Local Loopback (LL) and DTE Loopback tests.
LINE
BACKUP CC/DC
Backup
Line
CC/DC
11
V.35
EIA 232
V.35
EIA 232
495-14704