Tl1 Interface And Cli Test Commands - Paradyne 8922 Installation And User Manual

TL1 Interface and CLI Test Commands

The TL1 interface supported by SCP cards with an ATM uplink and CLI supported by
SCP cards with an IP uplink include the following commands related to MTAU and POTS
testing:
„
TL1: CHG-SPLIT
CLI: test mtau chg-split – If the mode is 2-Wire, this command splits the access
point and provides Look-Out connections to the Facility pair. If the mode is 4-Wire, it
splits the access point and provides simultaneous Look-In/Look-Out for the
Equipment and Facility pairs.
„
TL1: CHG-SPLIT-LILO
CLI: test mtau chg-split-lilo – If the specified direction is Equipment and the mode
is 2-Wire, this command splits the access point and provides a Look-In connection
to the Facility pair. If the specified direction is Equipment and the mode is 4-Wire, it
splits the access point and provides a Look-In connection to the Equipment pair. If
the specified direction is Facility, it splits the access point and provides a Look-Out
connection to the Facility pair.
„
TL1: CONN-LPACC-MET
CLI: test mtau conn-lpacc-met – Establishes an association between a port and
an active metallic test, and configures the test access mode for 2-wire or 4-wire.
„
TL1: CONN-MON
CLI: test mtau conn-mon – Establishes a bridged connection between the Facility
pair of the test jack and the selected unsplit line.
„
TL1: CONN-TACC-MET
CLI: test mtau conn-tacc-met – Provides a high-impedance monitoring
connection between the Facility pair of the test jack and the selected unsplit line.
„
TL1: DISC-TACC
CLI: test mtau disc-tacc – Stops a test and restores any existing split, resetting
the test access point to its original configuration before the CONN-LPACC-MET
command.
„
TL1: REPT-STAT – This is a user-issued heartbeat command. If a REPT-STAT is
not received within the timeout interval of 75 seconds, the current test is aborted,
isolating the test jacks. The CLI equivalent is to submit the same test command
again.
„
CLI: test pots-port loopback start – This command causes a test of the voice
service on a POTS port to start. The loopback is towards the network (uplink)
interface. The test will run for a period of 75 seconds.
„
CLI: test pots-port loopback stop – This command causes a test of the voice
service on a POTS port to stop prior to the test timeout period.
„
CLI: test pots-port ring-signal – This command initiates a manual Ring Signal on
the specified port.
See the 8620 and 8820 Broadband Access Concentrators TL1 Interface Reference and
the 8620 and 8820 Broadband Access Concentrators Command Line Interface
Reference for more information.
18