Table of Contents
Advertisement
Configuration and Management
18
12000E IP Broadband Loop Carrier Installation Instructions
Although no configuration is necessary to run subscriber lines at the default
settings, all 12000E parameter settings are software selectable via Command
Line Interface (CLI), Simple Network Management Protocol (SNMP), or the
Network Management System (NMS), depending upon the capabilities of the
management module model installed in your chassis. Once the management
module has been initialized, interface modules may be configured as desired
via whichever system(s) your management module is capable of running.
Refer to the following documentation for further information:
Table 1:
User Documentation
Document
Management module
installation instructions
(model-specific)
Uplink module
installation instructions
(model-specific)
Interface module user
guides
(model-specific)
CLI Management User
Guide
NMS Management User
Guide
Contents
module installation
port pinouts
parameter defaults
parameter configuration options
management system capabilities
module installation
port pinouts
parameter defaults
parameter configuration options
module installation
distance and bandwidth capabilities
port pinouts
parameter defaults
parameter configuration options
management module initialization
instructions
command user guide
command definitions
configuration options common to all
management module models
configuration options common to all
interface module models
management module initialization
instructions
screen by screen user guide
parameter definitions
configuration options common to all
management module models
configuration options common to all
interface module models
IPD1-A2-ZZ40-20
Advertisement
Table of Contents
