Zhone 12000E Installation Instructions Manual page 16

16
12000E IP Broadband Loop Carrier Installation Instructions
2 Detach the hook-and-loop fastener strap from the female RJ21 connector
port: lift the hook-and-loop fastener tab on the left and pull the strap open
towards the right, leaving it looped under the right side of the connector
frame.
3 Slide the male RJ21 connector of your interface cable underneath the
hook-and-loop fastener, from the bottom, and press it firmly into the
female RJ21 connector port on the chassis.
4 Pull the hook-and-loop fastener strap to the right, making sure that it is
snug against the connector, then pull the strap back towards the left, such
that the hook-and-loop fastener layers stick to one another across the top
of the connector. Tuck the tab at the end of the strap down to the left of the
connector frame so that it is out of the way of other connections and then
screw the top of the RJ21 cable connector into the jack screw at the top of
the RJ21 connector frame on the chassis. Note: If you are using a 120 or
180 degree cable, both the top and the bottom of the cable connector
should be screwed to the RJ21 connector frame on the chassis.
IPD1-A2-ZZ40-20