Table of Contents
Advertisement
Introduction
Unpacking and Inspecting the Equipment
4
12000E IP Broadband Loop Carrier Installation Instructions
The 12000E IP Broadband Loop Carrier (BLC) provides a high capacity and
native IP Ethernet foundation for a variety of feature-rich multi-service access
multiplexer modules.
The 12000E BLC is engineered for efficient, high-speed IP data transport in a
compact, fully fault-tolerant chassis. It features a high capacity backplane
delivering up to 48 Gbps throughput and providing a non-blocking
architecture for even the highest bandwidth broadband access technologies,
such as ADSL2+.
The 12000E BLC supports single or dual redundant uplink, management, and
switching modules. In redundant mode, both modules can be connected to the
dual backplanes with redundant modular backhaul/uplink ports to support 10/
100 Ethernet, GigE (Copper or fiber), T1/E1, and dual bonded T1/E1 uplink
modules.
For flexibility of installation the 12000E has removable mounting brackets
that can be placed in increments of 1.45" up to 9.28" from the front of the
chassis, allowing for multiple installation options in either 19" or 23"
equipment racks.
HANDLING PRECAUTIONS FOR
STATIC-SENSITIVE DEVICES
!
This product is designed to protect sensitive components from
damage due to electrostatic discharge (ESD) during normal
operation. When performing installation procedures, however, take
proper static control precautions to prevent damage to equipment. If
you are not sure of the proper static control precautions, contact your
nearest sales or service representative.
The following components should be included in the shipping container:
1 – 12000E with 1 fan module and 12 slot covers
4 – Rubber Bumper Screws
2 – Rack Mount Brackets (either 19" or 23", as ordered)
10 – #6 Phillips Bracket Screws
8 – #10 Phillips Rack Screws
8 – #12 Phillips Rack Screws
If there is visible damage, do not attempt to connect the device. Contact your
sales representative.
IPD1-A2-ZZ40-20
Advertisement
Table of Contents
