Installing The Hotwire 5446 Rtu - Paradyne Hotwire 5446 Installation Instructions Manual

Installing the Hotwire 5446 RTU

Place the Hotwire 5446 RTU on a flat surface with clearance for the rear connectors.
"
Procedure
1. Use the RJ11 6-pin cable for the DSL connection. Insert one end of the cable into
the jack labeled DSL. Insert the other end into the wall jack labeled DSL.
Hotwire RTU
DSL
Jack
If the Hotwire 5446 RTU is installed on the same line as POTS, a Hotwire 5038
Distributed POTS Splitter can be used as a filter. One 5038 Distributed POTS
splitter is installed as a filter for each telephone, as shown below. To install the
Hotwire 5038 Distributed POTS splitter, refer to Hotwire 5038 Distributed POTS
Splitter Customer Premises Installation Instructions.
Customer
Premises (CP)
Distributed
POTS Splitter
Line from
RJ11 Wall Jack
Distributed
POTS Splitter
97-15300-01
Distributed
POTS Splitter
Line from
RJ11 Wall Jack
8
Hotwire
RTU
98-15813