Paradyne Hotwire 5446 Installation Instructions Manual page 7

The Hotwire 5446 RTU connects to the local loop via wiring from the demarcation point
to an RJ11 wall jack. The DSL twisted-pair wiring from the local loop terminates at a
new or existing wall jack. It may be necessary to install a standard single RJ11 jack or
replace a single jack with a double RJ11 jack.
Demarcation Point
Central
Office
POTS/DSL
Local Loop
Punchdown
Block or NID
"
Procedure
1. Wiring can be run from the
punchdown block or NID to a
new or existing wall jack. Match
the pair colors on both ends.
2. Label the DSL jack.
3. Reconnect the DSL access pair
at the punchdown block or NID.
Refer to Installing the DSL
Access Wiring , page 5 . Tighten
both terminal screws with a flat-
blade screwdriver.
The RJ11 6-pin jack uses the center two pins. For pin assignments, refer to
Connectors
, page 17.
Customer Premises
DSL
Twisted-pair
Wiring
DSL
RJ11
Jack
RTU
97-15343-02
RJ11 Wall Jack
or
7
97-15300a
Cables &