Paradyne Hotwire 5446 Installation Instructions Manual page 10

3. Place the large ferrite choke on
the Ethernet cable as closely as
possible to the RTU. Pass the
Ethernet cable through the
ferrite choke twice, creating
a loop as shown.
4. Close the two halves
around the cable and
snap the ferrite choke
shut. Press down on the
plastic latch to secure
the ferrite choke in place
around the cable.
5. Insert the power cord's round end into the jack labeled POWER. Attach the ferrite
choke on the power cord as closely as possible to the RTU. Pass the power cable
through the ferrite choke twice, creating a loop as shown.
Hotwire RTU
Power
Jack
Ferrite
Choke
6. Close the two halves around the cable and snap the ferrite choke shut. Press down
on the plastic latch to secure the ferrite choke in place around the cable.
7. Plug the transformer into an AC outlet.
Hotwire RTU
or
10
Ethernet
Line
Ferrite
Choke
97-15796
496-14952
97-15303c