Declaration Of Conformity - Paradyne Hotwire 5446 Installation Instructions Manual

Rtu customer premises

Hide thumbs Also See for Hotwire 5446:

Table of Contents

Japan

Class 2 ITE

This is a Class 2 product based on the standard of the Voluntary Control Council for

Interference from Information Technology Equipment (VCCI). If this is used near a radio

or television receiver in a domestic environment, it may cause radio interference. Install

and use the equipment according to the instruction manual.

Declaration of Conformity

This Declaration of Conformity is made by Paradyne Corporation pursuant to Parts 2

and 15 of the Federal Communications Commission's Rules. This compliance

information statement pertains to the following products:

Trade Name:

Model Number:

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) this device may not cause harmful interference, and (2) this

device must accept any interference received, including interference that may cause

undesired operation.

The name, address, and telephone number of the responsible party is given below:

Paradyne Corporation

8545 126th Avenue North

Largo, FL 33773-1502

Phone: (727) 530-2000

The authority to operate this equipment is conditioned by the requirement that no

modifications will be made to the equipment unless the changes or modifications are

expressly approved by Paradyne Corporation.

In order to maintain compliance with Part 15, FCC rules, the clamp-on ferrite chokes

must be installed on the Ethernet cable and the Power cable in accordance with the

installation instructions.

Hotwire

5446-A2-200

Table of Contents