Cables & Connectors - Paradyne Hotwire 5446 Installation Instructions Manual

Example using TCP/IP Network Settings with Windows 95:
Set up the network configuration. Use the network settings in the Windows environment
to enter the default gateway, IP address, and subnet mask.
1. To configure the end-user system, from the Control Panel window, select:
Network
2. From the TCP/IP Properties window, select Gateway and enter the 5446 RTU's
IP address.
3. From the IP Address window, enter the IP Address and Subnet Mask. Select OK.
NOTE:
Any application supported by the service provider should now start up.
Increasing the Number of End-User Systems
A single end-user system is attached to the Hotwire 5446 RTU by using an Ethernet
crossover cable. To increase the number of end-user systems, connect all end-user
systems to an Ethernet hub using straight-through Ethernet cable. Refer to Installing the
Hotwire 5446 RTU on page 8.
The initial IP address for the first end-user system remains in effect when the end-user
system is reconnected. All new end-user systems must be configured by the service
provider.
The 5446 RTU can support up to 32 end-user systems using static or dynamic IP
addressing. The number of end-user systems can be increased on the network with the
use of subnets utilizing static addresses or connecting to a default gateway. Coordinate
additional IP addresses and subnet masks with the service provider.
Cables & Connectors
Use standard twisted-pair CAT3 or better cables.
This section is reference information.
DSL interface connector uses a 6-pin,
non-keyed modular plug.
RJ11 6-Pin Connector
Pin # Function
1 & 2 Not used
3 DSL Ring
4 DSL Tip
5 & 6 Not used
Configuration TCP/IP
DSL
Cable
RJ11 Plug
Pin #6
14
6-Pin
Pin #1
98-15304-01