Increasing The Number Of End-User Systems; Cables And Connectors - Paradyne HotWire 5446 Installation Instructions Manual

Increasing the Number of End-User Systems

A single end-user system is attached to the 5446 RTU by using an Ethernet crossover
cable. To increase the number of end-user systems, connect all end-user systems to an
Ethernet hub using straight-through Ethernet cables.
The initial IP address for the first end-user system remains in effect when the end-user
system is reconnected. All new end-user systems must be configured by the NSP.
Coordinate additional IP addresses and subnet masks with the NSP.
The 5446 RTU can support up to 32 end-user systems using static IP addressing. The
number of end-user systems can be increased on the network with the use of subnets
utilizing static addresses. Verify any planned changes with the NSP.
Cables & Connectors
Use standard twisted-pair CAT3 or better cables.
This section is reference information.
The DSL interface connector uses a 6-pin, non-keyed modular plug.
RJ11 6-Pin Connector
Pin # Function
1 & 2 Not used
3 DSL Ring
4 DSL Tip
5 & 6 Not used
14