Advertisement
GLIDER – BUTTERFLY
Menu 1:
Menu 2:
GLIDER – TRIM MIX 1
OFFSET
OFFSET
OFFSET
GLIDER – V-TAIL
Can be used for V-tail rudder differential,
or for adjusting the V-tail movement.
Magnus Hedlund
(Brake)
GROUP = 'Grp'
STATUS = INH
Then set flight condition = 'LANDING'
GROUP = 'Sngl'
STATUS = ON
OFFSET = 8
AIL=
-10
AIL2 =
-10
FLAP =
+140
FLAP2=
+140
ELE SETTING:
RATE 1 = 0
RATE 2=
+60
CURVE = Point
Position
Rate
152
0
83
0
70
-70
50
-115
0
-135
-50
-145
-100
-150
-152
-150
(Set aileron/flap neutral position for selected flight conditions)
GROUP = 'Sngl'
STATUS = INH
STATUS = ON
AIL
AIL2
0
0
FLAP
FLAP2
0
0
ELEVATOR
0
Adjust in/Out speed when changing between flight condition positions:
(If model type is V-Tail)
Group = 'Grp'
(Start with common settings)
(Set INH in flight conditions for no Butterfly
(Only for flight condition 'LANDING')
(Set ON in-flight condition 'LANDING')
(Set pos for Brake stick J3 activates 'LANDING')
(Aileron brake up
)
, or down
(Flap brake down, with the Brake stick J3 down
"+140" is the best value for max brake.)
(Elevator down compensation when braking)
(Not used, when no brake eq. J3 = up
(Gain for elevator down, affects the whole curve)
The curve needs to be set during flight test:
(This curve is a good start to begin with.)
(INH = for flight condition 'CRUISE', 'LANDING'
and 'MOTOR ON')
(ON = for the other flight conditions)
(Set aileron neutral position, down or up)
(Set flap neutral position, down or up)
(Set elevator neutral compensation, if needed)
Speed, for all flight conditions (option)
Page 5
Advertisement
