Table of Contents
Advertisement
(2) Do not apply torsion or bending moment other than the weight of the product itself. The
external piping should be supported separately because it may cause breakage.
(3) Non-flexible piping such as steel piping will be subject to excessive moment load and
vibration from the piping side, so use a flexible tube for intermediate connection.
(4) If the failure of the product will cause danger in the system, install a safety circuit and
configure the system so that danger can be avoided.
(5) Be sure to confirm the port indication when connecting the product.
(6) Before piping, perform air blow (flushing) or cleaning to remove any cutting chips,
cutting oil, dust, etc. from the piping.
(7) When installing piping or fitting into a port, prevent cutting chips and sealant material
from getting inside the piping. If a sealant tape is used, leave 1.5 to 2 threads exposed.
Caution
(1) Do not apply force when transferring, mounting and dropping the regulator with a
pressure gauge.
This may cause misalignment of the pressure gauge pointer.
Wrap this way.
Leave
2 threads.
Sealant tape
Handling
-10-
Advertisement
Table of Contents
Need help?
Do you have a question about the IR1010 and is the answer not in the manual?
Questions and answers