Controlling Your Tv With The Supplied Remote - Zenith VCS442 Installation And Operating Manual

CONTROLLING YOUR TV WITH THE SUPPLIED REMOTE

36
You can control your TV using the buttons below.
By pressing You can
POWER Turn the TV on or off.
INPUT Switch the TV's input source
between the TV and other input
sources.
CH +/– Scans up or down through
memorized channels.
VOL +/– Adjust the volume of the TV.
MUTE Turns on or off TV sound.
Depending on the unit being connected, you may not be able
to control your TV using some of the buttons.
CONTROLLING OTHER TVS WITH THE REMOTE
You can control the sound level, input source, and power
switch of non-LG TVs as well. If your TV is listed in the table
below, set the appropriate manufacturer code.
1. While holding down TV POWER button, press the number
buttons to select the manufacturer code for your TV (see
the table below).
2. Release TV POWER button.
CODE NUMBERS OF CONTROLLABLE TVS
If more than one code number is listed, try entering them one
at a time until you find the one that works with your TV.
Manufacturer Code Number
LG / GoldStar 1 (Default), 2
Zenith 1, 3, 4
Samsung 6, 7
Sony 8, 9
Hitachi 4
Depending on your TV, some or all buttons may not function
on the TV, even after entering the correct manufacturer code.
If you enter a new code number, the code number previously
entered will be erased.
When you replace the batteries of the remote, the code num-
ber you have set may be reset to the default setting. Set the
appropriate code number again.