Watching Tv Through The Vcr - Zenith VRD2125 Operating Manual

P A G E 2 0 O P E R AT I O N

Watching TV Through the VCR

This page shows a typical video system and explains how to select channels.
Cable TV
Wall Jack
Direct Cable
Back Panel of Typical Cable Box
CH3 CH4
From
Cable- TV IN OUT
System
Selecting Channels when the VCR is OFF
1. Turn TV on.
2. Select channel you'd like to watch at the TV. If you have
a cable box, select channel 3 or 4 at the TV. Select cable
box channels at the cable box.
Selecting Channels at the TV when VCR is ON
1. Turn TV and VCR on.
2. Place VCR in TV mode by pressing the TV/VCR button on
the remote control repeatedly until the VCR indicator
disappears from the front panel of the VCR.
3. Select channel you'd like to watch at the TV. If you have
a cable box, select channel 3 or 4 at the TV. Select cable
box channels at the cable box.
All-Channel
Back Panel of Stereo VCR
Antenna
AUDIO
Or
IN OUT
IN OUT
VIDEO
Or
Cable Box
Output
to VCR
R
ANT.IN
VCR Output to TV
L
(Channel 3 or 4 when
VHF/UHF VCR is on and TV/VCR
/CATV
is in VCR position)
3 4
CH.
Audio/Video Output to TV
Selecting Channels at the VCR when VCR is ON
1. Turn TV and VCR on.
2. Place VCR in VCR mode by pressing the TV/VCR button on
the remote control repeatedly until the VCR indicator
appears in the front panel of the VCR.
3. Select channels 3 or 4 at the TV. If your TV is equipped
with A/V input jacks, check your TV operating manual to
select the A/V source for a better picture.
4. Select the channel you'd like to watch at the VCR. If you
have a cable box, select channel 3 or 4 at the VCR.
Select cable box channels at the cable box.
Zenith TV
R-AUDIO-L VIDEO
OUT OUT
Cable/
IN IN
Antenna