Connecting To The Water Supply - Electrolux EWH 30 MXM WiFi EEC User Manual

When selecting locations for mounting bolt
holes, make sure that both sides of the bath-
room walls or other room up to the water
heater body there is a clearance of at least
0.2 m and at least 0.5 m on the pipe connec-
tion side to facilitate access for maintenance
when necessary.
If the water heater is supplied directly from
wells, wells or water towers, a coarse filter
for the cold water entering the water heater
must be used to operate the water heater. The
coarse filter can be purchased from specialty
stores. If the coarse filter is not installed, the
product warranty is not valid.
The electric water heater must be installed
on a solid vertical surface (wall). The instal-
lation of MXM WiFi EEC series water heat-
ers is greatly facilitated by the possibility to
install them both vertically and horizontally
anywhere in your home, in a heated (!) room.
It is advisable to install the heater as close
as possible to where the hot water is used,
because the shorter the length of the pipes,
the less heat is lost. As shown in Fig. 5. When
installing the heater close to a wall, leave the
recommended clearance for maintenance. Do
not install the heater on a horizontal surface
and up against the floor. After selecting the
mounting location, locate the two fastening
bolts with hooks (depending on the specifica-
tions of the selected product). Make two holes
in the wall to the required depth correspond-
ing to the size of the mounting bolts, insert the
screws, rotate the hook upwards, tighten the
nuts firmly and then install the electric water
heater on it (see Fig. 4). If the bathroom is too
small to accommodate the water heater, it
can be installed in any other room, protected
from direct sunlight and rain.
Fig. 4. Mounting anchor for mounting.

Connecting to the water supply

To connect the water heater to the water
mains use pipes with a diameter of G1/2.
Warning!
It is not recommended to use any additional
materials for the installation of the flex-
ible hose and the safety valve that are not
included in the water heater. The coupling
nut of the flexible hose has a rubber gasket
that ensures a tight connection between the
hose and the safety valve. When tightening,
avoid sudden jerking forces and limit the
tightening torque to 25-30 N*m.
Install complete rubber gaskets on the ends
of the threaded connections to prevent leaks
when connecting the piping.
If you want to implement a water supply sys-
tem for several water points, use the connec-
tion method (see Fig. 5).
1. Tees
2. Relief valve
3. Drain tube
4. Drain hose
5. Valves
Warning!
If the appliance is installed horizontally,
the water supply pipes must be on the left,
placement of the supply pipes on the right is
not allowed!
ENGLISH
Fig. 5
9