Repair
8. Install an o-ring (3*) on the groove at the bottom of
the outlet housing (1). Carefully slide the cylinder
(2†) into the outlet housing. Do not scratch the
polished inner surface of the cylinder.
9. Place an o-ring (3*) in the groove of the intake valve
housing (6†). Install the intake ball (4†). Insert the
ball stop pin (5†) in the desired holes.
14
10. Install the four tie bolts (7) through the outlet
housing (1) and into the intake valve housing (6†).
Torque the bolts to 57-63 ft-lb (77-85 N•m).
11. Perform the Reconnect the Pump procedure, page
9.
3A7945A