Figure 3-4. Bp-Cc3301 + Bbb With Adapter Board; Figure 3-5. Top View Of Modified Bbb - Texas Instruments BP-CC3301 User Manual

Implementation Results
To make sure the BeagleBone Black boots up from the SD card, TI recommends to add a 100k Ohm resistor for
R93 on the top of the BBB, and remove the R68 resistor seen on the bottom of the BBB. Alternatively, you can
press and hold the S2 button on the BeagleBone board during power up if the hardware modifications were not
made. (see Figure 3-6 and
Lastly, adding a right angle header on the bottom of the BBB to easily connect the FTDI cable is optional. When
the adapter board is attached to the BBB, the FTDI cable can get pinched between the BBB and adapter board,
which can cause communication problems. (see
14 SimpleLink ™ CC3301 Wi-Fi 6 and Bluetooth
in Module (BP-CC3301)

Figure 3-4. BP-CC3301 + BBB with Adapter Board

Figure 3-7).
Figure

Figure 3-5. Top View of Modified BBB

® Low Energy BoosterPack
Copyright © 2023 Texas Instruments Incorporated
3-7).
™ Plug- SWAU130A – MARCH 2023 – REVISED DECEMBER 2023
www.ti.com
Submit Document Feedback