Table of Contents
Advertisement
Unpacking the product
6 UNPACKING THE PRODUCT
The solar collectors are packed in various ways depending on
the number of units supplied:
A
Packages of 1, 2 or 3 collectors
B
Packages of 5 collectors
C
In a pack of 10
Pallet contents:
− collector
− document envelopes containing instruction manual,
spare parts catalogue, bar code labels and data label.
9
Take care not to lose the two flat seal rings (1) located in the
corner profiles of each collector.
9
The instruction manual is an integral part of the solar con-
nector. Once located, read it thoroughly and keep it safe.
9
STORE IN A DRY PLACE AND DO NOT EXPOSE TO DIRECT SUNLIGHT
UNTIL THE TIME OF INSTALLATION! The packaging is not de-
signed to protect the product against rain or humidity. It can
also degrade if exposed to direct sunlight. Failure to comply
with these precautions could lead to irreparable damage to
the product.
9
A protective film is applied to the glass of the solar collec-
tor. On completion of installation, only remove this film if
you are going to put the system into service immediately.
7 HANDLING
Handling
− Remove the PVC wrapping to free the solar collector from
the pallet.
− Apply the data label (provided in the document envelope)
to the back of the solar collector
Once you have removed the outer packaging, proceed as follows
to unpack and handle the solar collector:
− Tilt the solar collector slightly and grip it at the four points
shown (A) to lift it.
− Use a hoist or other suitable lifting equipment to hoist
the solar collector on to the roof.
9
Wear suitable personal protective equipment and use suit-
able safety devices.
0
Do not dispose of packaging material into the environment,
or leave it within the reach of children, since it can become
a potential hazard. Dispose of packaging material in com-
pliance with applicable legislation.
0
Do not lift the solar collector by its water fittings.
A
C
Data label
RIELLO S.p.A.
Via Ing Pilade Riello 7 - 37045 Legnago (VR) - Italia
Codice . . . . . . . .
Modello . . . . . . .
Matricola . . . . . .
COLLETTORE SOLARE (neutro)
Codice . . . . . . . . . . . . . . . . . . . . .
Tipo . . . . . . . . . . . . . . . . . . . . . . .
Dimensioni. . . . . . . . . . . . . . . . . .
Superficie lorda . . . . . . . . . . . . . .
Superficie di apertura . . . . . . . . .
Superficie assorbitore . . . . . . . . .
Peso a vuoto . . . . . . . . . . . . . . . .
Massima pressione di esercizio .
Temperatura di stagnazione . . . .
Contenuto liquido . . . . . . . . . . . .
Massima concentrazione glicole .
Liquido termovettore . . . . . . . . . .
FABBRICATO IN ITALIA da Riello S.p.A.
7
B
1
1
A
A
A
A
1
Advertisement
Table of Contents
