Carrier AquaEdge 19XR3-E Start-Up, Operation And Maintenance Instructions Manual page 114

Step 5: Verify that IOT certificate status = "Present".
HMI Path: Main Menu → System Configuration → Network Diagnostic.
If no, the certificate must be loaded to proceed or other HMI must be used.
Step 6: Complete "Ping Test" to Modem. HMI Path: Main Menu → System Configuration → Network Diagnostic.
Type "Modem IP Address" (typically 169.254.1.2) into the "Server Address" of the "Network Diagnostic" menu.
Select "eth0" as the "Interface" and then select "Run PING test". If PIC6 can connect to the modem the "PING Test Status"
will change from "IN PROGRESS to "PASS".
Step 7: Complete "Ping Test" to Internet. HMI Path: Main Menu → System Configuration → Network Diagnostic.
Type 8.8.8.8 into the "Server Address" of the "Network Diagnostic" menu. Select "eth0" as the "Interface" and
then select "Run PING test". If PIC6 can connect to the internet the "PING Test Status" will change from "IN
PROGRESS to "PASS".
Passed Ping Test:
If no, call Smart Service Command Center.
Step 8: Complete "Cloud Test". HMI Path: Main Menu → System Configuration → Network Diagnostic
Select "Run CLOUD Test". If PIC6 can connect to the modem the "Cloud Test Status" will change from
"IN PROGRESS to "PASS".
Passed Cloud Test:
If no, call Smart Service Command Center.
DESIGN CONDITIONS:
TONS BRINE
COOLER
CONDENSER
COMPRESSOR: Volts
STARTER: Mfg
OIL PUMP: Volts
CONTROL PANEL SUPPLY:
REFRIGERANT: Type
CARRIER OBLIGATIONS:
START-UP TO BE PERFORMED IN ACCORDANCE WITH APPROPRIATE MACHINE START-UP INSTRUCTIONS
JOB DATA REQUIRED:
1. Machine Installation Instructions . . . . . . . . . . . . . . . . . . .Yes
2. Machine Assembly, Wiring and Piping Diagrams . . . . . .Yes
3. Starting Equipment Details and Wiring Diagrams . . . . . .Yes
4. Applicable Design Data (see above) . . . . . . . . . . . . . . . .Yes
5. Diagrams and Instructions for Special Controls. . . . . . . .Yes
INITIAL MACHINE PRESSURE:
Was Machine Tight?
If Not, Were Leaks Corrected?
Was Machine Dehydrated After Repairs?
FLOW TEMPERATURE TEMPERATURE
RATE IN
RLA
Type
RLA
Voltage __________
Charge
Assemble . . . . . . . . . . . . . . . . . . . Yes
Leak Test . . . . . . . . . . . . . . . . . . . Yes
Dehydrate . . . . . . . . . . . . . . . . . . Yes
Charging . . . . . . . . . . . . . . . . . . . Yes
Operating Instructions

Yes No

Yes No

Yes No
(Y/N) ____
(Y/N) ____
(Y/N) _____
PRESSURE
PASS
OUT DROP
OLTA
S/N
OLTA
Hertz ________
 
No
 
No
 
No
 
No
Hrs.
 
No
 
No
 
No
 
No
 
No



CL-2
SUCTION CONDENSER
TEMPERATURE TEMPERATURE
******
******