Table of Contents
Advertisement
Adjusting the feet
A
WARNING: In order to
ensure that the product
operates more silently
and vibration-free, it must
stand level and balanced
on its feet. Balance the
machine by adjusting the
feet. Otherwise, the product
may move from its place
and cause crushing and
vibration problems.
• Loosen the lock nuts on the feet
by hand.
• Adjust the feet until the product
stands level and balanced.
• Tighten all lock nuts again by
hand.
A
WARNING: Do not use any
tools to loosen the lock
nuts. Otherwise, they will
get damaged.
Electrical connection
Connect the product to a grounded
outlet protected by a 16 A fuse. Our
company shall not be liable for any
damages that will arise when the
product is used without grounding
in accordance with the local
regulations.
• Connection must comply with
national regulations.
• The wiring for the electrical
outlet circuit must be sufficient
to meet the appliance
requirements. Use of a Groud
Fault Circuit Interrupter (GFCI) is
recommended.
• Power cable plug must be within
easy reach after installation.
• If the current value of the fuse
or breaker in the house is less
than 16 Amps, have a qualified
electrician install a 16 Amp fuse.
• The voltage specified in the
"Technical specifications" section
must be equal to your mains
voltage.
• Do not make connections via
extension cables or multi-plugs.
B
WARNING: Damaged
power cables must be
replaced by the Authorized
Service Agents.
Electrical requirements
Before you insert the plug into the
wall socket make sure that the
voltage and the frequency shown in
the rating label corresponds to your
electricity supply.
We recommend that this appliance
be connected to the mains supply via
a suitable switched and fused socket
in a readily accessible position.
Should the mains lead of the
appliance become damaged or
need replacing at any time, it must
be replaced by a special purpose
made mains lead which can only be
obtained from a Authorised Service
Agent.
EN
15
Advertisement
Table of Contents
