Router Description; Hardware Description - OneAccess ONE180 Installation Manual

3

Router Description

3.1

Hardware Description

This section details the various types of services offered by the ONE180. The
described configurations are the maximum configurations for the motherboard and
the extension modules. Other configurations can be derived by under-equipment.
Indeed, the ONE180 can have fewer interfaces compared to those presented below.
The acronyms mentioned in bold between brackets locate markings of the interfaces
back panel.
3.1.1 Motherboard Interface
The ONE180 motherboard is equipped with the following interfaces. The interface
marking is indicated in bold and between brackets.
•
1 G.SHDSL access network (2 or 4 wires) (SHDSL),
•
1 Console port (CONSOLE),
•
1 Managed switch 4 ports (SWITCH).
Optional Interfaces factory mounted:
•
WLAN 802.11b/g with 2 antennas (managed by the method « antenna
diversity »).
3.1.2 Extension Modules
Additional services are available in option on the daughter-board described below.
3.1.2.1 2 BRI and 2 FXS board
This board in its complete configuration has the following interfaces. The interface
marking is indicated in bold and between brackets.
•
2 ISDN Basic Rate Interfaces S0/T0 configurable TE or NT mode (ISDN
BRI),
•
2 Analog voice interfaces FXS (FXS).
3.1.2.2 4 BRI and 2 FXS board
This board in its complete configuration has the following interfaces. The interface
marking is indicated in bold and between brackets.
•
4 ISDN Basic Rate Interfaces S0/T0 configurable TE or NT mode (ISDN
BRI),
8
ONE180 – Installation Manual