Table of Contents
Advertisement
Installation Instruction
Installation of roof system
The installation of a GX-850M ver. IV with 1 roof system has been selected.
It is optional if the sensors are connected to the GX-850M ver. IV before power on or during the
installation.
The system uses the output System A.
If sensors for System A are not connected - do it now!
Press
or wait...
System is being scanned to find type of connected sensors...
Select system type: Roof
Wait until correct number of sensors for System A is found.
Press
when all sensors are found...
System A is installed...
System is being checked...
to configure System A.
Press
(Naming sensors and changing factory settings)
Please refer to "Changing parameters and performance of
systems" in "User Manual" for description of the configurable
parameters.
If for some reason you do not wish to configure the system now you can press
configuration of system.
Press
to end configuration.
VUAPA422
GX-850M ver. IV
:
Connect sensors
System A
System A
Scanning...
System type:
Roof
1 Roof sensor
found. Accept?
System A!
Installed
Checking system
<------>
Config system:
System A
to skip
Press to end
configuration.
© Danfos 2018.10 | 17
Advertisement
Table of Contents
