User Settings; Power On/Off; User Interface; Speed / Single Trip Distance / Odometer - King-Meter Digital II User Manual

5. User Settings

5.1 Power On/Off

Long press "MODE" button for 2 seconds then the display will power on, and the display will turn on
the controller. In power on state, long press "MODE" button to turn off the power supply of the e-bike.
In power off state, the display no longer use the battery power. The leakage current is less than 1 uA.
If the E-bike has not been used for 10 minutes, the display will turn off automatically.

5.2 User Interface

5.3 Speed / Single Trip distance / Odometer

After the display is powered on, the display will show the current default speed. Short press the "MODE"
button briefly to switch the display information. The sequence of display is:
Real-time speed (Km/h) → Average speed of this trip (Km/h) → Maximum speed of this trip (Km/h)
→Real-time speed (Km/h)
After the display is powered on, the display will show the odometer by default in the bottom of the
display (Km) Press and hold "MODE" and "DOWN" button for 2 seconds to switch the display
information. The sequence of display is:
KING-METER TECHNOLOGY CO., LT
No.15, Chenchang Road, Beichen Dist.Tianjin,300134, CN
Fax：+0086 022 8478 0358 Tel: +0086 022 8478 0378
5