Midea MAW08U1QWT User Manual page 38

Problem
Air conditioner turns on and off
rapidly.
Noise when unit is cooling.
Water dripping INSIDE when unit
is cooling.
Water dripping OUTSIDE when
unit is cooling.
Remote sensing deactivating
prematurely (some models).
Room too cold.
Noise when unit starts.
Window does not insert into the
U-shaped slot.
Unit will not connect to WiFi
or App does not work (some
models).
Solution
Dirty air fi lter- air restricted. Clean air fi lter.
Outside temperature extremely hot. Set FAN speed to a higher setting to
bring air past cooling coils more frequently.
Check for potential obstructions blocking the outdoor intake/exhaust.
Clear any obstructions.
Air movement sound. This is normal. If too loud, set to a slower FAN
setting.
Window vibration - poor installation. Refer to installation instructions or
check with installer.
Improper installation. Tilt air conditioner slightly to the outside to allow water
drainage.
Refer to installation instructions - check with installer.
Unit removing large quantity of moisture from humid room. This is normal
during excessively humid days.
Remote control not located within range. Place remote control within
26 feet & 180°, radius of the front of the unit, and pointed in the general
direction of the air conditioner unit.
Remote control signal obstructed. Remove obstruction.
Temperature setting too low. Increase temperature setting.
A 30 second high pitched noise may occur when the unit is turned on due
to the compressor starting. This is normal.
Ensure that the "U-shaped" slot is in line with the window, if not, align the
slot with the window.
Ensure that the unit is not slanted too much to cause interference with
the top of the unit. Reference the installation instructions for more
information.
For additional support and troubleshooting tips, visit the "Help" tab within
the MSmartHome app.
38