Midea MAW08U1QWT User Manual page 12

2. Prepare the Window – Install Video Time 1:58
Lower sash must open suffi ciently to allow a clear vertical opening of 13.75 inches. Side louvers and the rear of the
AC must have clear air space to allow enough airfl ow through the condenser for heat removal. The rear of the unit
must be outdoors, not inside a building or garage. Find the center of your window and lightly mark with a pencil.
3. Install Support Bracket – Install Video Time 3:12
A. Install the Main Support Bracket into the window opening.
Ensure that the Horizontal Bracket and Extension Arms are
located on the indoor side of the window.
WARNING
Maintain control of the bracket until installation is complete.
B. Move the Angled Support Arms toward the
exterior wall until the feet touch the wall.
Place the level on the bracket and adjust the
Support Arms so that it is level or tilted 1/4
bubble downward and towards the outside.
If exactly 1/4 bubble cannot be achieved,
set the angled support arms to the closest
setting so that a slight outward tilt exists.
NOTE
Bracket support legs extend 12" below windowsill.
C. Insert the Main Support Pin through the holes
in the Main Support and Angled Support Arm.
Match the hole numbers on both Main Supports
for alignment.
If further adjustment is needed, use alternate holes
where the Main Supports attach to the Horizontal
Bracket.
Fig. 4
12"
Fig. 5
12
Depending on the level
used, place at either
location below to
check level.
Here is what
1/4 bubble on
the level should
look like.
Fig. 6