Midea MAW08U1QWT User Manual page 22

4. ENERGY SAVER Feature
The energy saver feature is on by default, pressing the
button turns it off. This function is available on COOL,
DRY, and AUTO (only AUTO-COOLING and AUTO-
FAN) modes.
In this mode, the fan will continue to run for 3 minutes
after the compressor shuts off.
The fan then cycles on for 2 minutes at 10 minute
intervals until the room temperature is above the set
temperature, at which time the compressor turns back
on and Cooling Starts.
Check Filter Feature
The Check Filter Feature is a reminder to clean the air
fi lter for more effi cient operation. When it is time to
clean your fi lter, the fi lter indicator light will illuminate.
Clean your fi lter according to the instructions in the
Cleaning and Maintenance section, then reset the
fi lter light. To reset, press and hold the Energy Saver
button for 3 seconds and the light will turn off.
5. FAN SPEED Button
Press Fan button to select the Fan Speed in four
steps - Auto, Low, Med or High. Each time the
button is pressed, the fan speed is shifted.
6. UP/DOWN Button
Press UP ( ) or DOWN (
temperature setting.
7. MODE Button
• To choose the operating mode, press the MODE
button. Each time you press the button, a mode is
selected in a sequence that goes from Auto, Cool,
Dry and Fan. The indicator light beside the button
will be illuminated and remain on once that mode
is selected.
• When the unit is turned off and back on via the
power button, the unit will automatically switch
on the Energy Saver Function for the following
modes: Cool, Dry, Auto.
To operate on AUTO feature:
• When you set the air conditioner to AUTO mode,
it will automatically select cooling or fan only
operation, depending on what temperature you
have selected and the current room temperature.
) button to change
• The air conditioner will automatically control the
room temperature according to the temperature
you've set.
• In this mode, the fan speed cannot be adjusted
and is automatically controlled based on the
temperature setting and room temperature.
To operate on COOL mode:
• Choose Cool Mode to set the cooling function.
Use the UP ( ) or DOWN (
the desired temperature. When Cool Mode is
selected, the fan speed can be adjusted by
pressing the fan button.
To operate on DRY mode:
• In this mode, the air conditioner will generally
operate as a dehumidifi er. Since the conditioned
space is a closed or sealed area, some degree of
cooling will continue. On Dry mode, the fan speed
is not adjustable.
To operate on FAN mode:
• Use this function only when cooling is not desired,
such as for room air circulation. You can choose
any fan speed you prefer.
• In Fan Only mode, the temperature can not be
adjusted and the display will show the actual
room temperature, not the set temperature as in
the cooling mode.
8. FlashCool Button
Press to turn FlashCool on or off.
In FlashCool mode, the air conditioner will run at
the highest fan speed and compressor speed to
provide additional cooling to reach the temperature
setpoint. Once the setpoint is reached, the unit will
continue to run the fan in high speed and stay in
FlashCool mode. FlashCool mode will end if:
You press the button again;
The unit is turned off;
The mode is changed;
The fan speed is changed;
ECO or sleep mode are enabled.
22
) buttons to choose