Table of Contents
Advertisement
1.2
Safety Instructions
1.2.1.
General Safety Instructions
NOTICE
Improper handling of the device may result in its damage.
▪
The TES201 enclosure, the sensing modules and the electronics board inside shall not be exposed to
unnecessary mechanical stress.
▪
Do not apply the supply voltage to the RS485 data lines.
▪
The TES201 electronics is sensitive to electrostatic discharge (ESD), appropriate protective measures shall
be taken when touching it.
▪
Use the TES201 only as intended and observe all technical specifications.
1.2.2.
Intended Use
The TES201 is a temperature (T) room sensor for integration in demand controlled ventilation and building
automation in residential and commercial applications. It is designed for indoor wall mounting.
WARNING
Non-compliance with the product documentation may cause safety risk for people and the entire
measurement installation.
The manufacturer cannot be held responsible for damages as a result of incorrect handling, installation, and
maintenance of the device.
▪
Do not use TES201 in explosive atmosphere or for measurement of aggressive gases.
▪
This device is not appropriate for safety, emergency stop or other critical applications where device
malfunction or failure could cause injury to human beings.
▪
The device may not be manipulated with tools other than specifically described in this manual.
NOTICE
Failing to follow the instructions in this user manual may lead to measurement inaccuracy and device
failures.
▪
The TES201 may only be operated under the conditions described in this user manual and within the
specification included in chapter 8 Technical Data.
▪
Unauthorized product modification leads to loss of all warranty claims. Modification may be accomplished
only with an explicit permission of E+E Elektronik Ges.m.b.H.!
1.2.3.
Mounting, Start-up and Operation
The TES201 has been produced under state of the art manufacturing conditions, has been thoroughly tested
and has left the factory after fulfilling all safety criteria. The manufacturer has taken all precautions to ensure
safe operation of the device. The user must ensure that the device is set up and installed in a way that does not
impair its safe use. The user is responsible for observing all applicable local and international safety guidelines
for safe installation and operation of the device. This user manual contains information and warnings that must be
observed by the user in order to ensure safe operation.
PLEASE NOTE
The manufacturer or his authorized agent can only be held liable in case of willful or gross negligence. In any
case, the scope of liability is limited to the corresponding amount of the order issued to the manufacturer.
The manufacturer assumes no liability for damages incurred due to failure to comply with the applicable
regulations, operating instructions or the specified operating conditions. Consequential damages are
excluded from the liability.
User Manual TES201
Room Sensor for Temperature | 4
Advertisement
Table of Contents
