Kenmore 970 Use & Care Manual page 15

NOTE: If your refrigerator has the type of Mounting
Clips shown in Figure 1B below, use this procedure,
Tools Required: None
To Attach the Toe Grille to the Mounting Clips:
• With the end of the Toe Grille against the side of the
Lower Hinge, align the two (2) Assembly Slots with the
two (2) Mounting Clips
= Snap the Toe Grille onto the Mounting Clips, (See
FiguresIA and I B)
NOTE: A properly mounted Toe Grille should have its edge
against the Lower' Hinge, and the back of theToe Grille tight
La_gainstthe refr gerator base
To Remove the Toe Grille:
o Carefully tilt the bottom edge of the Toe Gritte away from
the refrigerator base
= Pull the Toe Grille toward you until it "unsnaps" from the
Mounting Clips (See Figure 2)
For Cleaning:
Hand wash in Warm Soapy Water.
The Toe Grille and Mounting Clips are NOT
dishwasher safe Placing them in the dishwasher wil!
result in a warped and unusable Grille
C¢
"
i'1ll_l+E:flflt_l tixlll'J Daet a_r_ Sh_,,'_,
Figure 1A Figure 1B
Figure 2
NOTE: If your refrigerator has the type of Mounting
Clips shown in Figure 2 below, use this procedure,
Tools Required: None
To Attach the Toe Grille;
, Open the refrigerator door
o Line up the Toe Grille Assembly over the two large holes
on the front of the refrigerator base (See Figure 1).
Push the Toe Grille Assembly into the holes until the grille
snaps in place (See Figure !)
NOTE (some models): lfyourrefrigerator has a left hand i
door swing, the Toe Grille Buttons must be positioned on
J
the left side of the keyhole slots (See Figure 2)°
l NOTE: Both Toe Grille Buttons must be mounted on the
same side of the two keyhole slots..
NOTE= The Toe Grille should be flush with the side of the
refrigerator and not interfere with the Lower Hinge.
To Remove the Toe Grille:
, Grasp the Toe Grille on each side and pull directly
outward
o The grille assembly will pop out of the holes for easy
cleaning
For Cleaning:
Hand wash in Warm Soapy Water.
C/
Figure 1
Too G,,,,o __
_ Too GrlIIB
Figure 2
15