Kenmore 970 Use & Care Manual page 12

NOTE: Some models have "pocket"
handles, which are recessedinto the
side of the door, On these models,
only the hinges will need to be re-
versed.
I. Refer to the Toe
Grille Instructions
on page 15 to
remove the Toe
Grille (some
models) Snap off
hinge cover at top
of cabinet (some
models). With the
freezer door closed,
remove the two
screws attaching
upper hinge to
cabinet. Lift the
Your refrigerator is equipped with reversible door hinges. Hinging of the door can
be changed to the opposite side any time you wish An envelope containing extra
plastic hole plugs is included in some models. Turn the refrigerator control to OFF
Remove all food, bottles, and other items from the door Begin with freezer
door Completely remove one door before beginning the other'.
Tools Necessary: _ _:_ ._-k"-_ A KntfpU_e
4. Remove hinge
pin, hinge, and the
two screws
attaching the lower
hinge Save the
hinge, hinge pin,
washer (some
hinge up and off, Be sure to save screws and hinge for
reassembly lateL
2. Open the freezer
door enough to
allow it to be lifted
off the center hinge
H_nBe ?in
3. With the refrig-
erator door closed,
remove center
hinge pin (Note
the arrangement of
the upper aod
lower washers
(some models) on
the hinge pin_ The
washers must be
reassembled later
in the same
manner) Open
refrigerator door
enough to allow door to be lifted off the lower hinge
Remove the two screws attaching the center hinge, The third
outermost screw under the center hinge should be left in
place, Save hinge, pin, and washers (some models) for
reassembly later, Reinstall screws in original holes
models) and
screws for
reassembfy later_
5, Carefully
remove the hole
plugs from the
hinge holes in the
center mullion and
top of cabinet and
reinstall in the
opposite set of
holes
or
Hinge Pin
Washer
Lower Hi!go
In ploca
12