Download Print this page

Maytag NEPTUNE MAH-1 Use & Care Manual page 8

Hide thumbs Also See for NEPTUNE MAH-1:

Advertisement

Available languages

Available languages

EAT U RES coNT.
(Liquid
Chlorine
Bleach Only)
I. Add chlorine bleach to the bleach compartment.
Do not exceed the MAX FILL line.The liquid chlo-
rine bleach compartment will hold 3/4 of a cup.
2. Avoid
splashing or over-filling
the compartment.
Over-filling
the
compartment
will
release
the
liquid
chlorine
bleach
into
the
clothes
washer
too early.
3. The washer automatically
dispenses bleach into the
tub when there are approximately
two minutes left
in the wash portion
of the cycle. This maximizes
the effectiveness of the bleach.
4. The dispenser automatically
dilutes liquid chlorine
bleach before it reaches the wash load.
NOTE:
• Never
pour undiluted liquid chlorine bleach
directly onto the load or into the tub. It is a
powerful chemical and can cause fabric
damage,
such as weakening of the fibers or color loss, if
not used properly.
• If you prefer to use color-safe, non-chlorine
bleach, add it to the detergent
compartment.
Do not pour
color-safe
bleach into the
bleach compartment.
SOFTENER
COMPARTMENT
............................................
I. Pour the recommended
amount of liquid fabric sof-
tener into the softener
compartment.
For smaller
loads use less than one cap full.
2. Fabric softener should be diluted with warm water
until it reaches the MAX FILL line on the compart-
ment. Do not fill above the MAX
FILL line. If
the
compartment
is filled above
the
MAX
FILL
line,
fabric
softener
will
enter
the
clothes washer
too early.
3. This compartment automatically
releases liquid fab-
ric softener
at the proper
time during the rinse
cycle.
NOTE:
• Use the softener compartment
only for liquid
fabric softeners.
• Using the Downy Ball* is not recommended
with this washer. It will not add fabric softener
at the appropriate
time. Use the dispenser on
top of the washer.
f
/,
*
Brand names are trademarks of the respectivemanufacturers.

Advertisement

loading