Advertisement
Available languages
Available languages
II!IEFORE
YOU
CALL
For problem
laundry
solutions
(i.e. fabric
damage,
residue,
tangling)
and special
laundry
care
procedures,
see the
enclosed
LaunderingTips
booklet.
•
Use Max Extract
option.
Load
is Too Wet
at
• Try using a high efficiency detergent to reduce sudsing.
End of Cycle
•
Load is too small.Very small loads (one or two items) may become unbalanced and not spin
out completely.
•
Make sure door is firmly closed.
•
Make sure hose connections are tight.
Leaks Water
•
Make sure end of drain hose is correctly
inserted and secured to drain facility.
• Avoid overloading.
•
Use high efficiency detergent to prevent over-sudsing.
•
Check fuse or reset circuit breaker.
•
Straighten drain hoses. Eliminate kinked hoses. If there is a drain restriction,
call for service.
Won't
Spin
•
Close the door and push the start/pause
pad. For your safer7, washer will not tumble or
or Drain
spin unless the door is closed.
• After pressing the start/pause
pad, it will take 30 seconds before the clothes washer begins
to spin.The door must lock before spin can be achieved.
•
See "Tub is Completely
Full of Suds" below.
•
Plug cord into live electrical outlet.
•
Check fuse or reset circuit breaker.
•
Close door and push the start/pause
pad to start the clothes washer. For your safer7,wash-
Stops
er will not tumble or spin unless door is closed.
• This may be a pause or soak period in the cycle. Wait briefly and it may start.
•
Check screens on inlet hoses at the faucets for obstructions.
Clean screens periodically.
•
Run the clothes washer through another complete cycle using cold water.
Tub is Completely
Full of Suds
•
Reduce detergent amount for that specific load size, soil level and water hardness.
•
Use high efficiency or low sudsing detergent
specially formulated
for front load washers.
• Turn both faucets on fully.
•
Make sure temperature
selection is correct.
•
Make sure hoses are connected to correct faucets. Flush water lines.
•
Check the water heater. It should be set to deliver a minimum of 120°F (49°C) hot water at
the tap. Also check water heater capacit7 and recovery rate.
Fills with the
•
Disconnect
hoses and clean screens. Hose filter screens may be plugged.
Wrong
• When
warm
rinse
is selected,
only
the
final
rinse
will
be warm.
The
first
two
Temperature
rinses will be cold.
Water
• As the washer is filling, the water
temperature
may change as the automatic temperature
control
feature checks incoming water temperature.
This is normal.
• While
the washer is filling, you may notice just hot and/or just cold water going through the
dispenser when cold or warm wash temperatures
are selected. This is a normal function
of
the automatic temperature
control feature as the washer determines
the temperature
of the
water.
I 0
CONT.
Advertisement
