Table of Contents
Advertisement
=
Line Selection
The unit will automatically select a free line which is not being used by a parallel
connected telephone when you make a call. The unit will select the called line
when you answer a Call. To change the line selection, program as follows.
The Talk indicator light must be off before programming.
1 Press (PROGRAM).
Save AUTO#
?
e The TALK indicator flashes.
V=Next
A=Yes
? Press SEARCH
(Next key) repeatedly
Line
selection?
until "Line
selection?" is displayed.
V=Next
A=Yes
3 Press SEARCH
(Yes key).
Line
selection
:Auto
V=Next
A=Save
ə The current selection is displayed.
Line 1: Line 1 will be selected.
Line 2: Line 2 will be selected.
Auto:
A free line will be selected (LINE 1 has
priority) when making a call. The called
line is automatically selected when
answering a call (factory preset).
4 Press SEARCH {M (Next key) repeatedly
Line seiced
until the desired line selection is displayed.
:Line2
V=Next
A=Save
5 Press SEARCH
(Save key).
Line
selection?
:Line2
e A beep sounds.
e The display wilt return to step 2. To return to
the stand-by mode, press
or wait for 60
seconds.
e To cancel during programming, press [EXIT] or (PROGRAM).
Start again from
step 1.
¢ if 3 beeps sound and the display shows "Save
error", move closer to the
base unit and try again. If "Save
error' is still displayed, place the handset on
the base unit. Start again from step 1.
e Any line can be selected manually, regardiess of the mode selected in step 4,
by pressing the line button.
. If a power failure occurs, the setting will return to the factory preset
(Auto). Reprogram if necessary.
45
OP
PEQ
Advertisement
Table of Contents
