Simplicity Regent EX Series Operator's Manual page 21

Check Tire Pressure
Tire pressure should be checked periodically, and maintained
at the levels shown in the chart (Figure 7). Note that these pres-
ÉËÈ»É Ã·Ï º¿ »È É¿½¾ÊÂÏ ¼ÈÅà ʾ» ·Î Ä ·Ê¿ÅÄ ÉÊ·ÃÆ»º ÅÄ Ê¾»
side-wall of the tires. The pressures shown provide proper trac-
tion, improve cut quality, and extend tire life.
Size
15 x 6.0-6
20 x 8.0-8
Check Mower Blade Stopping Time
Mower blades and mower drive belt should come to a com-
Æ»ʻ ÉÊÅÆ Í¿Ê¾¿Ä Ì» É»¹ÅÄºÉ ·¼Ê»È ʾ» »Â»¹ÊÈ¿¹  ÉͿʹ¾
¿É ÊËÈÄ»º Å
1. With tractor in neutral, PTO disengaged and operator in
seat, start the engine.
2. Look over the left-hand footrest at the mower drive belt.
Engage the PTO and wait several seconds. Disengage
the PTO and check the amount of time it takes for the
mower drive belt to stop.
¼ ÃÅÍ»È ºÈ¿Ì» ¸»ÂÊ ºÅ»É ÄÅÊ ÉÊÅÆ Í¿Ê¾¿Ä Ì» É»¹ÅĺÉ
see an authorized dealer.
en
PSI bar
12-14 0,82-0,96 bar
10 0,68 bar
Figure 7
Battery Maintenance
WARNING
When removing or installing battery cables,
disconnect the negative cable FIRST and
reconnect it LAST. If not done in this order,
the positive terminal can be shorted to the
frame by a tool.
Cleaning the Battery and Cables
1. Disconnect the cables from the battery, negative cables
ÈÉÊ A, Figure 8) then the cover and positive cables (B).
2. Loosen the wingnut and washer (D).
3. Pivot the hold-down rod (C) up and away from battery.
Secure to steering tower.
4. Remove the battery (E).
5. Clean the battery compartment with a solution of baking
soda and water.
6. Clean the battery terminals and cable ends with a wire
brush and battery terminal cleaner until shiny.
7. Reinstall the battery in the battery compartment.
Secure with the battery hold-down rod and wingnut
and washer.
8. Re-attach the battery cables, positive cables and cover
ÈÉÊ Ê¾»Ä ʾ» Ä»½·Ê¿Ì» ¹·¸Â»É
9. Coat the cable ends and battery terminals with petro-
leum jelly or non-conducting grease.
D
A
B
C
E
Figure 8
21