System Configuration Information - IBM Token-Ring Network PC Adapter Manual To Operations

Here are three more coding examples:
TOKREUI 400000000001,,400000000002
In this example '400000000001' is the address for the primary
adapter, and '400000000002' is the address for the alternate
adapter. The second comma in the list indicates that the default
value for the primary Shared RAM location is being retained.
The alternate Shared RAM location is also retained since nothing
is coded after the alternate adapter address in the list.
TOKREUI ,C400"DOOO
In this example 'C400' is the Shared RAM location for the
primary adapter, and 'DOOO' is the Shared RAM location for the
alternate adapter. The default addresses for the primary and
alternate adapters will be retained.
TOKREUI 400000000001,C400,400000000(J()2,DOOO
In this example, the defaults for both adapter addresses and both
Shared RAM locations have been changed.
System Configuration Information
The following procedure tells you how to configure your system
using the STACK line command.
1
Before starting the IBM Token-Ring Network, you should
add a line to the CONFIG.SYS file to allocate the
maximum number of stacks.
This allocation of stack resources reduces the likelihood of
the DOS internal stack error (see "The DOS Internal
Stack Error" on page 4-11) on an active IBM Token-Ring
Network. (This allocation of stack resources may not be
necessary for DOS version 3.3 or higller.)
4-9