Table of Contents
Advertisement
Chengdu Ebyte Electronic Technology Co.,Ltd.
* There will be some errors in the experimental test data, please refer to the actual physical test *
6.3 General Transmission Mode (Mode 1)
Type
When M0 = 1 and M1 = 0, the module works in mode 1
Subcontracted transmission according to 55 bytes per package using the air rate configured by the user;
send
The user can enter the data through the serial port, and the module will initiate the wireless transmission.
receive
In the non-transmitted state, the data can be received normally.
6.4 User configuration mode (mode 2)
Type
send
receive
configure
6.5 Sleep mode (mode 3)
type
send
receive
pay attention to
Copyright ©2012–2023，Chengdu Ebyte Electronic Technology Co.,Ltd.
Distance first
38400
Speed first
Distance first
57600
Speed first
Distance first
115200
Speed first
When M0 = 0 and M1 = 1, the module works in mode 2
Only the remote configuration instructions can be transmitted.
Only receive the remote configuration instruction responses.
The user can access the register to configure the module operating state.
When M0 = 1 and M1 = 1, the module works in mode 3
Unable to transmit the wireless data.
Unable to receive the wireless data.
When entering from the hibernation mode to the other mode, the module will reconfigure the
parameters, and the AUX remains low during the configuration process;
After the output high level, so it is recommended that the user detect the AUX rising edge.
E106-xxxTxxS User Manual
6.160
15.031
28.083
4.701
11.085
11.080
4.392
10.352
19.101
3.373
7.569
7.583
2.478
5.364
9.890
1.867
3.874
3.890
17
Advertisement
Table of Contents
