Transmission Mode (Mode 0); Rssi Mode (Mode 1); Ranging Mode (Mode 2); Configuration Mode (Mode 3) - Ebyte E28-2G4T27SX User Manual

Chengdu Ebyte Electronic Technology Co.,Ltd.
mode, if serial data not transmitted completely, it will enter new mode after all data is transmitted; if the module receives
data and send out through serial port, the module will enter new mode after the data is transmitted completely; so mode
switch will only be valid when AUX outputs 1, or switch will be delayed.
i.e.: under mode 2 or mode 4, when user inputs large amount of data continuously and conducts mode switch, the mode

switch is invalid; the module will conduct new mode check after all data is transmitted; so, users are recommended to check
the AUX pin status and conduct mode switch 2ms later when AUX outputs high level.
When the module enters configuration mode from other modes, it will enter sleep mode when all data is processed

completely (both TX and RX). This feature can be used for quick sleep to save energy; i.e.: the transmitter works under mode
0 and the user send
directly switches to sleep mode and put the user main MCU into sleep mode, the module will automatically enter sleep mode
1ms later when all data is processed so as to save the MCU working time and lower energy consumption.
Similarly, this feature can be utilized for any mode switch, the module will enter new mode automatically within 1ms when

current even is processed completely, which saves the user's efforts in checking AUX status and enables quick mode switch;
for example, when switching from transmitting mode to receiving mode, the user MCU could enter sleep mode before mode
switch, mode switch can be made by acquiring AUX change with external interrupt function.
This operation is very flexible and efficient, it is designed based on convenient MCU operation, and it could ease the

operation load of the entire system and increase the operation efficiency and lower the energy consumption.

6.2. Transmission Mode (Mode 0)

Under this mode, transparent transmission is available, that means the data transmitted from the transmitter will be received

by the receiver in the original format. Under normal mode, the two sides could communicate with each other normally based
on same air data rate, address and channel; under continuous transmission mode, the baud rates on both sides must be the
same, it supports large file continuous transmission under baud rate from 1200bps ~ 115200bps.

6.3. RSSI Mode (Mode 1)

Under this mode, the module will output current RSSI value of 2.4GHz signal every 100ms so as to check the channel quality,

the value is in HEX compliment format.

Ranging Mode (Mode 2)

6.4.
(Reserved)

6.5.
Configuration mode

Under this mode, Baud rate is fixed as 9600 8N1
Copyright ©2012–2020, Chengdu Ebyte Electronic Technology Co., Ltd.
serial data"12345", then the user does not need to wait till the AUX enters idle state (high level) and
(Mode 3)
E28-2G4T27SX User Manual
10