Ebyte E610 T S Series Product Manual page 22

100mw/1w wireless high-speed continuous transmission module
Table of Contents

Advertisement

Chengdu Ebyte Electronic Technology Co.,Ltd.
Read /
05H
REG2
write
Read /
06H
REG3
write
CRYPT
07H
write
_H
CRYPT
08H
write
_L
Copyright ©2012–2023,Chengdu Ebyte Electronic Technology Co.,Ltd.
1
0
transmitting power
0
0
20 / 30 dBm (by default)
0
1
17/27d B m
1
0
14/24d B m
1
1
11/21d B m
Channel Control (CH)
0 – 62 represent a total of 62 channels,
respectively
7
Receive the data package RSSI
0
Close (default)
1
open
6
transmission mode
0
Transparent transfer (by default)
1
Fixed-point transmission
5
Relay function
0
Close (default)
1
open
4
3
2
1
0
Key High Bytes (default 0)
Key Low Bytes (default 0)
transmission mode, the first
frame data from the receiver
can be output after 3ms.
* Only distance priority is
supported at 230,400 baud
rates.
* Power and current are a
non-linear relationship, when
the maximum power, the power
supply efficiency is the highest;
* Current will not decrease with
power.
* Actual frequency = 410 MHz +
CH * 0.5 MHz, default 433
MHz = [0x2E].
* Range of values: 410 MHz ~
441 MHz, [0x00] ~ [0x3E].
* Only for general transmission
mode;
* When enabled, the module
receives the wireless data,
output through the serial TXD,
will follow an RSSI strength
byte to indicate the signal
strength when receiving the
data;
* Conversion formula: dBm =
RSSI / 2-154.
* Only for general transmission
mode;
* During the fixed-point
transmission, the module will
identify the first three bytes of
the serial port data as: high
address + low address +
channel, and take it as the
wireless transmission target.
* Only for general transmission
mode;
* When the relay function is
enabled, if the target address is
not the module itself, the
module will start a forwarding;
* To prevent data return, it is
recommended to work with
fixed mode; namely, the target
address and source address are
different.
continue to have
* Write only, read back to 0; for
encryption to avoid airborne
wireless data intercepted by
similar modules;
* These two bytes will be used as
the calculation factor to encrypt
the airborne wireless signal.
E106-xxxTxxS User Manual
21

Advertisement

Table of Contents
loading

This manual is also suitable for:

E610-433t 20sE610-433t 30sE610-900t 30sE610-900t20s

Table of Contents