Table of Contents
Advertisement
Chengdu Ebyte Electronic Technology Co.,Ltd.
8 Use of the relay network mode
No.
After setting the relay mode through the configuration mode, switch to the general mode, and the relay starts
1
working.
In relay mode, ADDH and ADDL are no longer module addresses, but are matched according to NETID
2
forwarding. If one network is received, it is forwarded to another network; the network ID of the repeater itself is
invalid.
3
In relay mode, the relay module cannot send and receive data and cannot perform low-power operation.
From Mode 3 (sleep mode) to another mode or during reset the module reset user parameters during the AUX
4
output low level.
Description of the relay networking rules:
1、 Forward rule, the relay can forward data between two NETIDs.
2、In relay mode, ADDH \ ADDL is no longer used as a module address and serves as a NETID forwarding pairing.
as shown in the figure:
① Level 1 Relay
"Node 1" NETID is 08.
"Node 2" NETID is 33.
The ADDH \ ADDL for relay 1 was 08,33, respectively.
So the signal sent by node 1 (08) can be forwarded to node 2 (33)
At the same time, node 1 and node 2 have the same address, so the data sent by node 1 can be received by node 2.
② Secondary Relay
The ADDH \ ADDL for relay 2 was 33,05, respectively.
So the relay 2 can forward the data of the relay 1 to the network NETID: 05.
Thus, the nodes 3 and the node 4 can receive the node 1 data. Node 4 normally outputs data, and node 3 has different
addresses from node 1, so it does not output data.
③ Bi-directional relay
As configured, data nodes 2 and 4 sent by nodes 1 may be received, and data sent by nodes 2 and 4 may also be received
by nodes 1.
Copyright ©2012–2023，Chengdu Ebyte Electronic Technology Co.,Ltd.
Relay mode description
E106-xxxTxxS User Manual
23
Advertisement
Table of Contents
