Yamaha PLG150-DX Owner's Manual page 70

Extract DX Bulk Dump Data
• The following information pertains only to the Plug-in Editor.
This is used for importing the DX voice data contained in a host application sequence
data to the DX Simulator. Specify the range (Start and End points) from which you want
to extract the data. All current voice data will be replaced by the extracted data. This
function has no effect if there is no DX voice data in the specified range.
• "Extract DX Bulk Dump Data" can also be selected from the toolbar.
• Start
Measure / Beat / Clock
This determines the beginning point in the track from which the DX bulk dump data will
be extracted. You can specify the Measure (Meas), Beat, and Clock.
• End
Measure / Beat / Clock
This determines the end point in the track from which the DX bulk dump data will be
extracted. You can specify the Measure (Meas), Beat, and Clock.
• OK
Click this to extract the data at the specified location.
• Cancel
Click this to abort the operation.
Setup Menus /
70
Extract DX Bulk Dump Data