Yamaha PLG150-DX Owner's Manual page 67

• MIDI In
Settings: Device, In port number
This determines which MIDI input device (interface) and port is used for transmitting DX
Simulator data.
• MIDI Out
Settings: Device, Out port number
This determines which MIDI output device (interface) and port is used for sending DX
Simulator data. There are four available devices/ports, as specified in the System Setup
parameters (Setup → System Setup). (For details on System Setup, refer to the host
application's manual.)
• MIDI Channel
Range: 1 ... 16
This determines which MIDI channel is used for sending DX Simulator data. Set this to
match the receive channel for the Part you wish to control.
• Part Number
Range: 1 ... 16
This determines which Part is to be used for the DX voice.
• Device Number
Range: 1 ... 16
This determines which tone generator the DX Simulator will send data to. This should be
set to same number as the Device Number of the tone generator/sound card to which the
PLG150-DX is installed. If you have multiple tone generators in your MIDI setup and
each is set to a different Device Number, this parameter lets you select which tone gener-
ator will be affected by the DX Simulator. If you are using only one tone generator, this
should be set to "1."
• Board Number
Range: 1 ... 8
This determines which tone generator card (or board) the DX Simulator will send data to.
If you have multiple tone generator cards in your MIDI setup and each is set to a different
Board Number (in numerical order from 1), this parameter lets you select which card will
be affected by the DX Simulator. If you are using only one tone generator card, this is
automatically set to "1."
• Output when edited
When this is checked, any edits that you make with the DX Simulator are instantly and
automatically transmitted to the PLG150-DX. This ensures that you can audition edits as
soon as you make them.
Setup Menus /
67
DX Simulator Setup