Yamaha MU10 Owner's Manual page 33

MIDI Data Format
[ QS300 NATIVE ]
1) QS300 User Normal Voice Data
2.2.1 XG Native Bulk Dump
11110000 F0 Exclusive status
01000011 43 YAMAHA ID
0000nnnn 0n Device Number
01001100 4C XG Model ID
0bbbbbbb bb Byte Count
0bbbbbbb bb Byte Count
0aaaaaaa aa Address High
0aaaaaaa aa Address Mid
0aaaaaaa aa Address Low
0ddddddd dd Data
| |
| |
0ccccccc cc checksum
11110111 F7 End of Exclusive
For the Address and Byte Count, refer to the
supplementary tables.
The checksum is the value that results in a value of
0 for the lower 7 bits when the Start Address, Byte
Count, plus the checksum itself are added.
2.2.1.1 XG System Data bulk dump
See Tables 1-1 and 1-2.
2.2.1.2 Multi Effect1 Data bulk dump
See Tables 1-1 and 1-3.
2.2.1.3 Multi Part Data bulk dump
See Tables 1-1 and 1-4.
2.2.1.4 A/D Part Data bulk dump
See Tables 1-1 and 1- 5
2.2.1.5 Drums Setup Data bulk dump
See Tables 1-1 and 1-6.
2.2.2 QS300 Native Bulk Dump
Up to 32 Voices created by the QS300 can be saved in
the MU10's User Memory by bulk dump messages.
(Effective only when the XG mode is active.)
QS300 User Voices are stored in Bank MSB = 63,
LSB = 00. Program Change numbers for User Voices
are 1-32.
11110000 F0 Exclusive status
01000011 43 YAMAHA ID
0000nnnn 0n Device Number
01001011 4B QS300 Model ID
0bbbbbbb bb Byte Count
0bbbbbbb bb Byte Count
0aaaaaaa aa Address High
0aaaaaaa aa Address Mid
0aaaaaaa aa Address Low
32
0ddddddd dd Data
| |
| |
0ccccccc cc checksum
11110111 F7 End of Exclusive
* Because of possible differences in number of
elements, some QS300 Voices may sound slightly
different.
2.2.2.1 QS300 User Normal Voice Data bulk
dump
See Tables 3-1 and 3-2.
3. REALTIME MESSAGES
3.1 Active Sensing
Once FE has been received, if no MIDI data is
subsequently received for longer than an interval of
approximately 300msec, the MU10 will perform the
same function as when ALL SOUNDS OFF, ALL
NOTES OFF, and RESET ALL CONTROLLERS
messages are received, and will then return to a status
in which FE is not monitored.
TRANSMISSION
When the HOST SELECT switch is set to other than
"MIDI", data received via TO HOST terminal is
relayed to MIDI OUT terminal.
If the data received via TO HOST terminal includes
port message, the only data with the port message
specified in MULTI PORT NUMBER for MIDI OUT
( Table 2-2 ) is relayed to MIDI OUT terminal.