Flex LBE 125 18.0-EC Manual page 9

LBE 125 18.0-EC/LB 125 18.0-EC/L 125 18.0-EC-LD
Mounting clamp-fit hood
Remove battery.

Open clamping lever (1.).

Attach clamp-fit hood with clamping ring

to clamping flange, guiding cams on
clamping ring into groove on flange when
doing so (2.).
Turn clamp-fit hood in clockwise direction

to the desired position (3.) and tighten the
clamping lever (4.).
Remove in reverse order.

Attach the handle
NOTE
It is not permitted to operate the electric
power tool without the handle.
Attaching/changing the tool
Remove the battery.

Attach the grinding wheel
Press and hold down the spindle

lock (1.).
Using the pin wrench, loosen the

clamping nut on the spindle in an anti-
clockwise direction and remove (2.).
Insert the grinding wheel in the correct

position.
Screw the clamping nut with flange face

up, onto the spindle.
Press and hold down the spindle lock.

Tighten the clamping nut with the pin

wrench.
Carry out a test run to check that the tool

is clamped in the centre.
Test run
Insert the battery.

Switch on the angle grinder with the

switch (without engaging it) and run the
angle grinder for approx. 30 seconds.
Check for imbalances and vibrations.
Switch off the angle grinder.

25