Flex LBE 125 18.0-EC Manual page 10

Switching on and off
Brief operation without engaged switch
rocker
Press switch (1.), push towards front and

hold (2.).
To switch off the power tool, release

the switch rocker.
Continuous operation with engaged
switch rocker
Press switch (1.), push towards front (2.)

and engage at front end by applying
pressure (3.).
To switch off the power tool, release the

switch rocker by pressing the rear end.
NOTE
Following a power failure, the switched on
power tool does not restart.
26
LBE 125 18.0-EC/LB 125 18.0-EC/L 125 18.0-EC-LD
Preselecting the speed
(for LBE 125 18.0-EC)
To set the operating speed, press the

speed control button. Selected speed is
maintained even when switching off.
Gently press the switch to accelerate the

power tool up to the preselected speed.
Risk of injury due to destruction of the tool.
Use the appropriate tool for the job.
Overload protection: switches the
–
machine off in the event of overload.
Sensor-controlled temperature
–
monitoring: If there is a risk of
overheating the machine switches off.
Adjusting the guard
To adjust the tool to the task at hand, the
guard hood can be adjusted by 12 notches
on 360° without a tool.
Risk of injury! Wear protective gloves.
Remove the battery.

CAUTION!
NOTE
CAUTION!