DMIPADDLE FAMILY - OPERATING MANUAL // PAGE 6
2 SAFETY
2.1
TARGET AUDIENCE
This Operating Manual is intended for Skilled Persons only. Refer to Chapter 2.8 Skilled Persons on page 9 to
ensure that personnel meet all requirements.
2.2 GENERAL SAFETY REGULATIONS
In general, the following safety regulations and obligations apply when handling the product:
• Do not operate the product unless it is in a clean and perfect condition
• Do not remove, change, bridge, or bypass any protection, safety, or monitoring equipment
• Do not convert or modify any components without written approval from LOGICDATA
• In the event of malfunction or damage, faulty components must be replaced immediately
• Unauthorized repairs are prohibited
• Do not attempt to replace hardware unless the product is in a de-energized state
• Only Skilled Persons are allowed to work with DMIpaddle Family handsets
• Ensure that national worker protection conditions and national safety and accident preven-
tion regulations are observed during operation of the system
2.3 INTENDED USE
The products in the DMIpaddle Family Handset are for electrically Height-Adjustable Tables. They are in-
stalled by Resellers into Height-Adjustable Table systems. They are used to control Height-Adjustable Table
systems via an integrated Control Unit in the connected DYNAMIC MOTION Actuator. They are intended
for indoor use only. They may only be installed in compatible Height-Adjustable Table Systems and with
LOGICDATA-approved accessories. Contact LOGICDATA for further details. Use beyond or outside the in-
tended use will void the product's warranty.
2.4 REASONABLY FORESEEABLE MISUSE
Usage outside of the intended use may lead to minor injury, serious injury, or even death. Reasonably fore-
seeable misuse of the Handset includes, but does not extend to:
• Connecting unauthorized parts to the product. If you are unsure as to whether a part can be
used with a Handset, contact LOGICDATA for further information
Need help?
Do you have a question about the DMIpaddle Series and is the answer not in the manual?