Each Setting And Adjustment; Pcl Output Confirmation - Pioneer MVH-350BT/XMEW5 Service Manual

1
3. Fit the spring in the groove at the position shown in the figure.
4. Fit the boss on the lower side of the arm in the lower hole of
the panel, and then warp the rib on the panel in the direction
A
shown in the figure and fit the boss of the arm in the panel.
B
C
D

8. EACH SETTING AND ADJUSTMENT

8.1 PCL OUTPUT CONFIRMATION

- PCL Output
In the normal operation mode (with the detachable panel installed, the ACC switched ON, the standby mode
cancelled), shift the TESTIN IC601(Pin 99) terminal to H.
The clock signal is output from the PCL terminal IC601(Pin115).
E The frequency of the clock signal is 600 kHz that is divided by 20th of the oscillation frequency of X601 (12MHz).
The clock signal should be 600 kHz(- 25 Hz, + 25 Hz).
If the clock signal is out of the range, the X'tal (X601) should be replaced with new one.
F
22
1
2
MVH-350BT/XMEW5
2
3
3
4
Fig.8
4