Each Setting And Adjustment; How To Update Firmware - Pioneer VSX-LX52 Service Manual

1

8. EACH SETTING AND ADJUSTMENT

8.1 HOW TO UPDATE FIRMWARE

Version Indication
A
[Purpose]
The versions for Syscon EMMA, EVENT con and DSP firmware are displayed.
[Preparations]
1. Power on only the Main zone.
2. Set the main volume level to -79.5 dB.
[How to enter]
1. Press "HOME MENU" key of the remote control unit and displays HOME MENU screen.
2. On that above conditions, simultaneously press and hold "ENTER" and " MULTI-zone CONTROL" keys
for more than 10 seconds.
B
[How to exit]
Simultaneously press and hold "ENTER" and " MULTI-ZONE CONTROL" keys for short seconds. (The volume level is free.)
Or turn off the power.
[Check GUI Display sample]
C
D
Syscon (EMMA), EVENT con and DSP Flash ROM Update by USB Memory
UPDATE PANEL Mode (Version update)
[Preparations]
1. Copy the UPDATE FILE to the root directory of the USB Memory.
2. Turn off the power to this unit by setting Multi-Zone to "OFF".
3. Connect the USB Memory to the USB terminal (A type) of the front panel.
[Procedure]
1. While holding down "TUNE+" key on the front panel, press "STANDBY ON/OFF" key and
moves to the UPDATE PANEL mode.
2. The updating process is as follows.
E
UPDATE PANEL2 Mode (Version down and same version install)
[Preparations]
1. Copy the UPDATE FILE to the root directory of the USB Memory.
2. Turn off the power to the unit by setting the main volume to "---db" and Multi-zone to OFF.
3. Connect the USB Memory to the USB terminal (A type) of the front panel.
[Procedure]
1. Simultaneously press and hold "TUNE+" and "MULTI-ZONE ON/OFF" keys for about 5 seconds and
moves to the UPDATE PANEL2 mode.
2. The updating process is as follows.
F
The FL display and procedure of the updating process is same for both mode.
For UPDATE PANEL 2 Mode, after completing the update, it is necessary to
disconnect then reconnect the AC cord of the unit.
60
1
2
The display design is subject to possible modifications.
VSX-LX52
2
3
3
4
4