Table of Contents
Advertisement
d.
Disconnect the two thicker cables from the reverse ZIF connectors (4) on the board.
The touch control board is available as spare part number N87231-001.
NOTE:
When replacing the touch control board or display panel, be sure to update the touch
firmware, which is available on the
14.
To remove the hinges from the display enclosure:
a.
Remove the Phillips M2.0 × 3.0 screw (1) from each hinge.
b.
Remove the three Phillips M2.0 × 2.0 screws (2) from each hinge.
c.
Remove the display hinges (3).
The display hinges are available using spare part number N87228-001.
15.
To remove the WLAN antennas:
a.
Peel the wireless antennas (1) off the bottom of the display rear cover.
HP product support
page.
Display assembly
55
Advertisement
Table of Contents
