Table of Contents
Advertisement
k.
Disconnect the cable (4) from the panel.
l.
When installing a display panel, be sure to install the tape on the left and right sides of the
display back cover as shown in the following illustration. Display panel tape is included in the
display component spare part kits that require you to remove the display panel to access and
replace.
NOTE:
When replacing the touch control board or display panel, be sure to update the touch
firmware, which is available on the
NOTE:
Note that the display tape pull tabs are not located next to the edges of the display,
but are positioned slightly more toward the inside of the display.
The display panel is available using spare part number N87242-001.
11.
To remove the camera module:
a.
Insert a tool at the two locations (1) shown in the following illustration.
NOTE:
Be sure to insert the tool at the locations shown in the following illustration. These
locations are reinforced with metal to prevent damage during removal.
b.
Carefully lift the module (2) to release it from the display back cover. The module is attached
with double-sided adhesive.
HP product support
page.
Display assembly
51
Advertisement
Table of Contents
